文献类型：期刊文献

中文题名：超声辅助滚压系统研究

英文题名：The research of ultrasonic assisted rolling system

作者：唐军[1];李文星[1];赵波[2]

第一作者：唐军

机构：[1]新乡学院机电工程学院;[2]河南理工大学机械与动力工程学院

第一机构：新乡学院机电工程学院

年份：2018

卷号：37

期号：3

起止页码：330-337

中文期刊名：应用声学

外文期刊名：Journal of Applied Acoustics

收录：CSTPCD;;北大核心:【北大核心2017】；CSCD:【CSCD_E2017_2018】；

基金：河南省高等学校重点科研项目(18A460029);国家"863"计划资助项目(2013AA040103)

语种：中文

中文关键词：超声辅助滚压;表面粗糙度;表面硬度;有限元分析

外文关键词：Ultrasonic assisted rolling, Surface roughness, Surface hardness, Finite element analysis （FEA）

摘要：鉴于风力发电机组主轴的复杂工作情况和疲劳断裂失效形式,提出一种基于表面强化技术的超声辅助滚压加工系统。首先基于运动合成原理,获得了滚轮接触线的运动轨迹特征,并应用ANSYS/LS-DYNA软件分析了加工过程的特点。之后,基于一维振动理论、等效波长理论与牛顿迭代理论,推导并求解了复合变幅杆的频率方程,实现了该复合变幅杆的纵向振动。通过对该变幅杆进行有限元仿真分析与振动特性测试,结果表明二者相对设计频率的偏差仅在0.817%以内。最后,通过对40Cr主轴进行超声辅助滚压测试,获得了粗糙度Ra 0.085μm和表面硬度32.2 HRC的加工表面,较普通滚压加工粗糙度降低了69.1%,显微硬度提高了60%。
In view of the complicated loading conditions and fatigue failure forms of the turbojet enginespindle, an ultrasonic assisted rolling system based on the surface strengthening technology is proposed. Firstly,based on the principal of motion synthesis, the trajectory characteristics of the roller contact line are obtained,and the processing characteristics are analyzed by using the ANSYS/LS-DYNA software. Then, based on theone dimensional vibration theory, equivalent wavelength theory and Newton iteration theory, the frequencyequation of compound horn is deduced and solved, and the longitudinal vibration of the composite horn isrealized. Through the finite element simulation analysis and vibration characteristic test of the compoundhorn, the result shows that the two methods are in good agreement with the theoretical analysis, and theresonance frequency error is within 0.817%. At last, the ultrasonic assisted rolling test of 40Cr spindle wascarried out, the machined surface with roughness of Ra 0.085 m and hardness of 32.2 HRC was obtained. Thesurface roughness is reduced 69.1% and the hardness increased 60% compared with the conventional rollingprocess.